Problems with heat treatment equipment
Thread Content
The equipment requires overall heat treatment. There is no diagram of the welding pads for the equipment when it arrives at the site – how can this issue be resolved on-site? Class 3 devices, thank you, expert
This really shouldn’t be done; in theory, the gasket plates should be welded back at the factory before undergoing heat treatment again. If the amount of welding required for the gussets on site is not large, it is possible to discuss with the design team the option of carrying out local heat treatment after welding; this depends on the distribution of the gussets, the amount of welding needed, and the purpose of the original heat treatment.