Operation mode for regenerating boiler softening resin
Thread Content
It is required that the regeneration fluid can enter the resin tank without the need for a pump or a salt suction valve, and that its preparation should be automated. Have you seen such a device before?
With such advanced technology, it should be possible to achieve this, but I really haven’t seen it done yet; I’ll ask the water treatment manufacturers
Salt suction valve? It’s the dilute salt valve, right? It should be a counter-current regeneration sodium ion exchanger; how can the dilute salt regeneration solution be fed into the ion exchanger without a pump?
I’m also wondering; there should be a pump. The requirements are as follows: “The salt tank should be made of carbon steel lined with rubber, and the traditional salt intake valve should be removed, with automatic control over the water and salt levels.” Automatic proportioning of recycled brine, no salt pump required. ”
Excluding the “salt suction valve” which is outside the ejector, what comes to mind is using compressed air to “push” it in； The acid tank is installed at a very high position. There has to be some motivation, either through word games or through actual technological progress. If the original poster gets any further updates, remember to CALL me so I can learn from it.