Vertical oil branch support problem, with a total height limit of 2m
Thread Content
As shown in the diagram, I am now designing a vertical oil separator with an inner diameter of 500 mm, a thickness of 8 mm, and a total height limited to within 2 meters. I would like to use standard leg-type supports, but the supporting height H is too large. Now I am considering moving the support pads upward to meet the height requirements; I’m not sure if this is feasible or whether recalculation is needed. Thank you to all the experts out there.
Place three support points at random positions at the lower end of the housing, and connect them to the three legs below in order to create a more attractive appearance; the ends of the legs can be fixed together using bolts. You might as well give it a try.
A few ear mounts can be made; those ear mounts can be supported using channel steel. The upper support plate is connected to the ear mounts, while the lower base plate functions similarly to a leg base plate.