When calculating the reinforcement rings for pressure vessels, a message appears stating: \"Be careful with the operating conditions of the reinforcement rings...\" What could be the problem here?
Thread Content
How can the red-texted area shown in the image be removed? It also meets the requirements after checking Section 6.3.2 of GB150.
Qualified. If the actual reinforcement area is larger than the required reinforcement area, it serves as a reminder to check whether the reinforcement ring can be used with that device Not all equipment can be reinforced with reinforcing rings; it must meet the requirements of GB150 in order to be used. If the takeover is not on the centerline of the cylinder, the reinforcement ring should be oval rather than circular; therefore, it is necessary to ensure that the width of the reinforcement ring is not less than the calculated width.
There is no problem; such a warning appears in all reinforcement calculations for openings that have reinforcement rings.