Is it feasible to use a three-blade swept-type impeller for stirring in experimental polymerization reactors?
Thread Content
Our unit is currently planning to install a PVC experimental polymerization system. Is it possible to use a two-layer mixing system for stirring? Where is the installation location? Additionally, I would like to ask whether most of the existing polymerization reactors use variable-frequency mixing, and if there is a power curve for the mixing process
Which book contains calculations for the mixing device in a polymerization reactor?
It probably isn’t in the book either; it seems that most of it relies on experience, with some calculation formulas available
The number of mixing cycles depends on the capacity of your equipment. If the speed is required to be within a range, such as 0-200 r/min, inverters are available for that. If it’s at a constant speed, it can be omitted. The mixing power can be calculated based on the voltage and current of the motor; if you request it, corresponding meters will be available on the control cabinet to display this value.