Calculation method for wall thickness of high-pressure small-volume vessels
Thread Content
How to calculate the wall thickness of a small container with a pressure above 50Ma and a diameter below 150mm? Can you refer to 150 for calculation? Are there any other standard controls?
If the pressure application range exceeds GB/T150, it must be calculated according to JB4732-95 analysis and design standards.
You can refer to GB150 for calculation. You can also refer to pressure pipes for calculations. Of course, you can also calculate according to JB/T4732, but the cost is higher.
It can be used as a reference, but it is not within the standard range and cannot convince customers. The cost of each pressure test is very high.
How much additional cost will each pressure test cost?
If the diameter is less than 150, it can be designed according to the pressure pipeline.