[Discussion Post 37] How to determine the edge rib line of the saddle?
Thread Content
This post was last edited by kareale88 on 2019-4-16 08:49 bg4.png [Discussion Post 37] How to determine the edge rib line of the saddle? Is the line of the side ribs parallel to the line of the saddle? When drawing this picture: Which wire should be determined first. As shown in the picture: Red mark.
This post was last edited by kareale88 on 2019-4-16 09:41: Handshake is great, the upper part is confirmed. What about the lower part? There are two values (10. 15) in the lower part. If we want to ensure that the three lines should not be parallel? Can the line passing through the center point of the circle be parallel to the middle line and intersect with the base plate?
I think they are parallel. The edge of the web is determined. Just use the edge O (offset) of the web.
I understand it personally, I don’t know if it’s right or not
The picture on the software VCD I saw is like this: The positioning of 10mm and 15mm at the bottom is guaranteed, but the 15mm positioning at the bottom after yours is offset from the web line cannot be guaranteed, right?
I think we should use the middle line (the red line in the picture) as the base line, draw a tangent line from bottom to top, then copy the web line and offset the inner rib line. Guaranteed 10 and 15
The key point of the idea is to use the auxiliary line to make the circle, and then draw the tangent line from bottom to top: handshake. Thank you very much.
Agree with learning* your new method