SW6 gear clamp calculation-BUG

2019-07-17View Original

Thread Content

Parts Design ---》When calculating the tooth clamp, the edge moment at the connection between the flange ring and the flange neck is as follows: MHHG/T20582-2011: When the actual calculation software is calculated, the first parenthesis of the denominator should be omitted, and the following formula appears in the calculation book. The above situation did not appear before the first version of SW6 V3.1 was patched, but it appeared after patching and in V4.0. As a result, S1 and S5 always fail to pass the calculation.

Reply #22019-07-17

The problem is very simple. This problem has been around for a long time. I hope I can contact the equipment station and fix it next time.

Reply #32019-07-17

You can send an email to pjchang@tced.com to report the situation

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

SW6 gear clamp calculation-BUG

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links