Takeover opening reinforcement
Thread Content
Dear experts, regarding oval end caps, how should one calculate the reinforcement for openings in those nozzles that are neither parallel to the centerline of the end cap nor parallel to the normal line at the opening?
This post was last edited by fzujunru on 2021-1-17 at 15:43. This method using SW6 cannot be applied; however, the equal-area method remains valid when the ratio of the long and short axes of the opening is less than 2. The equal-area method does not impose any restrictions on the angle of the fittings, and reinforcement for non-radial fitting openings can be carried out in accordance with Chapter 6 of HG20582, either through manual calculations or using ANSYS
Standard reinforcement rings can also be used, as specified in JB/T 4736-2002 Reinforcement Rings.
Bend the take over so that the junction with the head can be vertical.
I don’t know what the meaning of doing this is
I don’t know what the meaning of doing this is
Calculate manually in accordance with Chapter 6 of HG20582 for reinforcement of openings in non-radial nozzles.