Installation of the integrated wire mesh demister for lower units
Thread Content
For the X600-150 integrated mesh demister, how is it installed? There is a fixing ring on the mesh – what is the structure at the bottom? Is it welded directly? It seems that spot welding isn’t appropriate; it should be a detachable structure
The lower support component is detachable and secured with bolts. Component 12-0: There are certainly other components as well; the number of these fastening bolts is determined based on the diameter.
This post was last edited by wanlirn on 2021-8-25 at 09:53. The diagrams he drew show lower garments in a segmented format; the overall structure of lower garments is not of this kind； For this small-diameter type, both the lower and upper parts are the same; the lower grille is divided into two sections, four ear plates are welded, along with two strip plates, which are then connected to the ear plates using bolts. That’s all
If it is still in the design stage and not yet under construction, then change it to an upper-mounted type. The screen is placed below the lower flange, with ear plates welded on the upper flange to provide positioning. So do mature things worry too?