When the heat exchanger section partition and tube sheet are connected by welding, is it necessary to enter the cross-sectional area of the section partition?
Thread Content
As shown in the figure, when the heat exchanger split diaphragm and tube sheet are connected by welding, is it necessary to enter the cross-sectional area of the split diaphragm?
It is not necessary to enter the cross-sectional area of the partition. In the welding configuration, more attention is usually paid to the quality of the weld and the strength of the connection between the tube sheet and the partition plate, rather than the cross-sectional area of the partition plate itself. .
Is this a baffle for the shell side or a baffle for the tube side?
The cross-sectional area of the partition here is added to the gasket area to calculate the flange. I’m not quite sure about your structure – how are the cylinder and tube sheet connected? Is there a detail drawing?