Check of tube wall thickness in heat exchangers
2017-05-04View Original
Thread Content
Is there a formula for checking the wall thickness of pipes under external pressure?Related Threads in This Forum
← Previous
- Two issues encountered while using HTRI V7.3.2 – please ask
- Cause analysis of furnace tube leakage - HCBBS Forum
- What is the material of the shims used to adjust the height
- The world’s first detachable closed-cycle cooling tower! ! !
- Looking to buy used falling-film evaporators - HCBBS Forum
- 【Ten Years of Rapid Development in Chemical Equipment】5,000
- Problems that occur during the use of silicon carbide heat e
- What are the effects of water entering the heat transfer oil
- Heat exchanger design temperature and operating temperature
- Strength welding pipe joint leg dimension - HCBBS Forum
Next →
- Technical indicators of qualified heating steam - HCBBS Foru
- Axial flow heat exchanger axial flange calculation - HCBBS F
- Heat exchanger K value and non-condensable gas density - HCB
- Is it possible for an evaporator to evaporate 50 liters of w
- Method of drawing with three arcs to create a standard ellip
- I recommend a gasket specifically designed for heat exchange
- Determination of the central tube size in waste heat boilers
- distillation - HCBBS Forum
- What constitutes a reasonable result when using EDR for heat
- Seeking help in selecting an HTFS 2006+ plate heat exchanger
Translated at 2026-07-21 04:28:16
Original: https://bbs.hcbbs.com/thread-1775936-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.