Mechanical seal design issues
Thread Content
I would like to ask everyone: when designing mechanical seals, how are the dimensions of components such as the spring seat, thrust ring, rotating ring, as well as auxiliary parts like the gland determined? Is it based on experience, some standards, or calculations using formulas?
Where can I find this standard? How is the calculation done? Are there any recommended references? I can try to look for them myself
Could you give me some advice? I’m in a hurry
In accordance with national standards and relevant design calculations
Is there anyone who can guide me?
Is there anyone who can teach me? There will be a reward
\"Mechanical Design Handbook\", Volume 3, Part 10: Lubrication and Sealing, Chapter 3: Sealing, Section 8: Mechanical Seals 10-243 – See if it’s useful to you