I want to create an automatic device for crushing and conveying
Thread Content
The crystalline material in the 25-kilogram barrel, after being poured directly into it at 90 degrees, fully solidifies inside the barrel. Now, we break up the crystalline material inside by having workers use hammers to strike it, and then repack it. I want to create a device that uses automatic hammering to break up the crystalline material inside this tank. Automatic conveying would be best.
Can it be put in barrels after cooling down? Now, hitting it after it has solidified makes it difficult to control the timing and effect.
No, after cooling down, everything solidifies, and it’s no longer possible to keep it in the bucket, as the material will deliquesce once it comes into contact with air.
I’m not sure about this hardness; I wonder if it would be possible to use it for a spiral reamer? Inspired by the “meat grinder”.
No, the material is highly corrosive; stainless steel blades are prone to corrosion
I once used a slicing machine, but it tended to decompose when exposed to moisture, resulting in a low yield of the final product as well as a reduced efficiency