On the topic of the \"Compilation of Selection Standards for Corrosion Prevention Construction Engineers\"

Thread Content

This post was last edited by nj1952 on 2017-6-24 at 17:01. Topic: Compilation of Standards for Selecting Corrosion Prevention Construction Engineers. Book title: Compilation of Standards for Selecting Corrosion Prevention Construction Engineers. Series title: Compilation of Standards for Selecting Corrosion Prevention Engineers. Authors: Editorial Committee of the Compilation of Standards for Selecting Corrosion Prevention Engineers, Fifth Editing Department, China Standard Press. Publisher: China Standard Press. Publication date: 2007-9-1. Introduction: The Chinese Society for Corrosion and Protection compiled the \"Essential Books for Corrosion Prevention Engineers\" series; this compilation consists of three volumes: Compilation of Standards for Selecting Corrosion Prevention Design Engineers, Compilation of Standards for Selecting Corrosion Prevention Inspection Engineers, and Compilation of Standards for Selecting Corrosion Prevention Construction Engineers. This volume is part of the \"Compilation of Selection Standards for Corrosion Prevention Construction Engineers.\" It contains 24 engineering standards in the field of corrosion prevention that were approved and issued by the end of May 2007, of which 8 are national standards and 16 are industry standards. Relevant standards that were not included are listed in the appendix for easy reference. I. Since the publication of this “Compilation of Standards,” 10 standards have been revised and updated, and 3 new standards have been issued: GB/T 8923.1-2011 Surface treatment of steel surfaces prior to coating – Visual assessment of surface cleanliness – Part 1: Rust grades and treatment grades for untreated steel surfaces and steel surfaces from which the existing coating has been completely removed (replaces GB/T 8923-1988); GB/T 8923.2-2008 Surface treatment of steel surfaces prior to coating – Visual assessment of surface cleanliness – Part 2: Treatment grades for partially treated steel surfaces from which the existing coating has been removed; GB/T 8923.3-2009 Surface treatment of steel surfaces prior to coating – Visual assessment of surface cleanliness – Part 3: Treatment grades for surface defects such as welds, edges, and other areas; GB/T 8923.4-2013 Surface treatment of steel surfaces prior to coating – Visual assessment of surface cleanliness – Part 4: Initial surface condition, treatment grades, and flash rust grades related to high-pressure water jet treatment; GB/T 9793-2012 Thermal spraying – Metal and other inorganic coatings – Zinc, aluminum, and their alloys (replaces GB/T 9793-1997); GB/T 18593-2010 Corrosion-resistant coatings based on fused epoxy powder coatings (replaces GB/T 18593-2001); JB/T 10242-2013 General technical specifications for cathodic electrophoretic coating (replaces JB/T 10242-2001); SH/T 3022-2011 Design specifications for corrosion protection of petrochemical equipment and pipelines (replaces SH 3022-1999); SL 105-2007 Corrosion protection specifications for hydraulic metal structures (replaces SL 105-1995); SY/T 0315-2013 Technical specifications for fused epoxy powder outer coatings on steel pipelines (replaces SY/T 0315-1997); SY/T 0319-2012 Technical standards for liquid-coated inner anti-corrosion layers in steel storage tanks (replaces SY/T 0319-1998); SY/T 0326-2012 Technical standards for epoxy fiberglass linings in steel storage tanks (replaces SY/T 0326-2002); SY/T 0407-2012 Specifications for surface treatment of steel surfaces prior to coating (replaces SY/T 0407-1997).

II. The table of contents of the “Compilation of Standards for Selection of Corrosion Protection Construction Engineers” is attached below for your reference