Why is such a warning appearing for the data imported from Aspen into EDR?
Thread Content
Why is such a warning appearing for the data imported from Aspen into EDR? Version 8.4
Tip: The vapor-phase mol content in stream 1 is outside the allowable range; please check.
I understand what you mean, but I don’t know why such a problem occurs when importing from Aspen into EDR; the parameters in Aspen are fine
Then take a look at how the vapor fraction of this stream differs between A+ and EDR. Is it because the process goes through a pump valve in A+, which is not taken into account thermodynamically, whereas the phase state is automatically calculated in EDR?
Only the ten temperature points of the heat exchanger at three different pressures were input into EDR. It doesn’t involve pumps or valves; this kind of situation has never occurred before, and I’m not sure where the problem lies.
If I’m not mistaken, this error refers to the molecular weight.
But I checked, and the actual molecular weight entered is 3.286. I can’t even find where the numbers in this warning are?