Why is there a gas bubble in the vent pipeline in this diagram?
Thread Content
As the title suggests, as shown in the project, why go to the extra effort of including an air bag?
In my opinion, this should control the emission of non-condensable gases through the air resistance created by the air bag, similar to a control valve used to regulate venting
Does the equipment at the back have a water seal?
Guess: 1. To prevent fluid accumulation, especially its backflow into the tank; 2. To control the flow rate and avoid too fast flow rates during pressure release
This is for releasing non-condensable gas, to prevent liquid buildup? Can’t understand
The vent line leads directly to the pressure relief main
Won’t non-condensable gas contain liquid? Under normal conditions, what is expelled is at this saturation vapor pressure; once there is a drop in temperature or an increase in pressure, the liquid condenses.
Prevent the liquid in the discharge manifold from flowing back into the tank
Guess: To prevent too rapid pressure release by acting as a regulator and buffer, that is, for the reflux of condensate