It’s a forced arrangement made within a rather limited space; please give some advice – this is really tough. .
Thread Content
This post was last edited by shangdanyige on 2017-5-21 00:02
The layout is fairly reasonable; it’s just that the spacing is a bit small, unless the floor area is increased.
There’s no other way; unless the two pumps arranged one above the other are replaced with ones arranged side by side~~
The building area is as large as that green area
The layout is too compact, making installation, operation, and maintenance difficult
There’s really nothing that can be done with such a limited space, right?
Some grooves have been changed to lugs, with additional local laminations added to further optimize the equipment layout. The device size can also be adjusted appropriately to comprehensively modify the device layout. There are many methods; think more.
There is one issue I need to bring to your attention: your manufacturing process determines the equipment required, the equipment in turn determines the production process, and the production process affects the layout of the facility. It’s important to understand this sequence – the process comes first, followed by the construction of the factory building; it’s not right to build the factory building first and then try to fit in the equipment afterwards.