The torch issue
Thread Content
The H2S burner of the ground flare on the current installation is producing white smoke during combustion; is there any good solution for this? Is it possible to use some liquefied gas?
Is it water vapor? Too much moisture?
Is the amount of steam used for combustion too high? Can burning liquefied gas in combination with other fuels cause incomplete combustion of the flare gas?
I think the smoke-reducing steam is set too high
The steam isn’t turned on; it’s constantly releasing steam otherwise, which causes white smoke to appear
There’s no way to do it without steam; the smoke produced is too heavy
It’s suspected, but they don’t dare to release it – it’s too obvious
Add root purification air ducts for timely manual adjustment