Can pumping transfer the material from Reactor A to Reactor B completely?
Thread Content
When transferring material from Reactor A to Reactor B, will the pump not experience cavitation at the end of the transfer? Please explain whether this can completely remove the material
Of course, the air will become polluted by the end; just turn it off right after it’s over
Here, we stop the pump whenever we observe unstable pressure at the pump outlet, and then use the pump inlet drain line to empty it.
Actually, using vacuum extraction is also a very convenient method.
It’s possible to complete the process, but it causes significant damage to the pump’s mechanical seal; gas pressure can be used, or vacuum extraction can also be employed
Pump the liquid until the DCS level stops dropping; once the pressure gauge at the pump outlet shows fluctuations on site, it can be stopped