Two streams of steam with different temperatures and pressures are mixed; when using PRO II for modeling, clicking to run results in an error. I seek guidance from experts
Thread Content
The small factory plans to use medium-pressure steam (3.43 MPa, 325°C) to drive a backpressure steam-driven feedwater pump. The exhaust steam from the backpressure machine needs to be mixed with another stream of steam: Steam 1 has parameters of 0.8 MPa, 280°C, and 200 t/h, while Steam 2 has parameters of 0.9 MPa, 220°C, and 30 t/h. These two streams of steam are mixed together; the material specified for this mixture is WATER. The operation always fails when trying to start the system. I would be extremely grateful if someone could provide guidance
Based on your description, it should be the simplest logistics combination, and errors generally don’t occur. You can send the error message of the message to take a look
By replacing the Robinson equation with the Soave-Redich-Kwong equation, it can be run, and the simulation was successful
I’m a PRO II beginner; if there’s anything wrong, please feel free to point it out. @lt*aoying