How to calibrate a differential pressure transmitter
Thread Content
How to use a standard table to calibrate a differential pressure transmitter? I hope experts can provide specific steps on how to do this, as well as guidance on how to prepare the calibration report
The wiring for verification is as shown in the figure. Due to the limited precision of ammeters, digital voltmeters are mostly used during calibration to measure the voltage across the standard resistor, thereby obtaining the measurement results indirectly. The load resistance is set to 500Ω, and the output voltage ranges from 2 to 10V.DC, which improves the sensitivity of the readings on the digital voltmeter. The verification items include: zero point, range adjustment ； Linear adjustment ； It consists of several parts: damping adjustment, positive migration adjustment, and negative migration adjustment. Just follow the instructions for the specific operations.
It doesn’t make much sense – the precision of your equipment isn’t as high as that of the manufacturer’s products; in fact, it might not even be as precise as that of standard instruments. Using a 0.5-grade standard instrument to calibrate a 0.5-grade transmitter?
It’s just a process-based test; high precision isn’t required{:2_30:} I had the idea to create an assessment for us
There are indeed some devices; there’s a portable pressure calibrator said to cost over 200,000. But now we need to pass an assessment on standardized procedures, and since I’ve never done any calibration work, I’m not quite familiar with the process
The verification work you mentioned is usually carried out by the manufacturer
Could you share the accuracy, range, and price of your pressure tester?
In China, companies like Conest provide instruments at this price, but their accuracy level is not necessarily higher than that of other instruments. Take Rosemount pressure transmitters as an example: their accuracy grade is 0.1, and better grades are also available. According to the metrology regulations, an instrument must have several times higher accuracy in order to be calibrated
This post was last edited by cqdfwy on 2017-1-11 at 16:33. Provide the calibration specification JJG882-2004; study it carefully* and it can solve the problem.