The gauge of the Coriolis mass flow meter shows a full-scale value of cubic meters per hour; it was working normally before, handling fuel gas. After the start/stop mechanism was activated, the gauge again showed the full-scale value. The measurement was taken in a straight pipe – what could be the reason?
Thread Content
The display of the Coriolis mass flow meter shows the full scale in cubic feet per hour; this was normal before, as it was measuring fuel gas. After the start/stop mechanism was activated, the meter still showed the full scale value, and measurement was carried out in a straight pipe. What could be the reason? Thank you
Power off and restart; if that doesn’t work, perform a self-diagnosis
What kind of installation is it? Take it apart and check; there might be water in the measurement tube.