Where can I select the cross-reference for the Honeywell PKS400 function block?
Thread Content
I know where the cross-reference function is in PKS 300? For example: within the block corresponding to a valve’s circuit, it is possible to see which sequential control system references that valve; this is one such function. However, to use this function, it is necessary to enable PKS 400, and I don’t know where to do that
Does no one know? ? Just wait! ! !
Overall, there are not many changes in the core functions between 400 and 300. You’ll find out by trying a few times, or you can also look it up in the KB. Step 1: Go to CB, then select TOOLS>System Preferences…. Step 2: Check Display Cross-References….
In my post, I already mentioned that for 300, I know where it is, but for 400, there’s no option called “display cross” available
I’ll check in a bit to see if it says where it is in the 300 KB section; if so, I’ll go take a look at the 400 KB section as well. Is the KB section also divided into 300 and 400?
The screenshot I gave you shows 400
I’m confused – why doesn’t my 400 model have the “display cross” option? I’ll take a photo of it tomorrow; are there different types for the 400 model as well?