How was it damaged?
Thread Content
What caused it? The only solution is to replace the transmitter
Is it out of range? Can’t it be reset if the pressure tap is removed?
It’s good that it’s broken – if an old watch is broken, just use a new one. An old lover won’t stay with you forever...
The last edit to this post was made by 1111111 on 2018-6-9 at 13:37, with the change “Abnormal input data”. It is necessary to check the instructions to find out what is meant by input data; for sensors, the input data refers to the load applied, while for amplification circuits, it refers to the output signal from the sensor. Troubleshooting can only be carried out by considering these two aspects.
Resetting to factory settings doesn’t work either; the same fault keeps occurring
It should be the input pressure; changing the transmitter will fix the issue. Transmitters aren’t supposed to break that easily
The pressure tap was removed and the drain valve was opened, but the alarm continued to sound; it couldn’t be silenced