CS3000 system backup issues
Thread Content
Recently, our company installed an engineer station. The engineering files were backed up from the existing engineer station, and the parameters were adjusted and saved before the backup was taken. However, after installing the engineer station and opening the adjustment screen for the project file, the adjustment parameters are not visible; only asterisks appear. I don’t know why. I would appreciate it if that expert could give some advice!
It was opened on a standalone device; it’s not connected to a system.
This post was last edited by jlshnlhj on 2018-6-22 at 16:33: “It was opened on a standalone device; it wasn’t connected to a system.” ” What does it mean? Does it mean the control station is not connected? Of course not; the adjustment parameters visible when adjusting the screen are real-time data uploaded from the control station. The purpose of saving backup adjustment parameters is to be used for offline downloading after a control station goes offline for maintenance. (At that time, all the program data was lost; battery protection lasted 72 hours.) ）
When offline, it is necessary to simulate the corresponding FCS; otherwise it will show ※, as the controller is not connected