I hope experts can share information on high-frequency cable failures in E+H radar level gauges”
Thread Content
The FM51 radar level gauge we used on site kept experiencing \"high-frequency cable faults\" during operation; after replacing it, it functioned normally for a day before failing again. The selection of the gauge was appropriate based on the given conditions, but once the FM54 was installed, the gauge worked properly. I would like to ask what are the structural differences between 54 and 51? Detailed information would be appreciated. Thank you!
Detailed information on FMP51 and FMP54 can be downloaded from the Endershaus official website
Well, one of our level gauges has the same model as the one mentioned by the poster, and it also experiences frequent high-frequency cable failures. . Well, there’s a small damage on the stainless steel waveguide rod, an impact injury; the director said that’s the reason. We consulted the manufacturer at that time, and they said it was either the cable behind the motherboard or a fault with the motherboard, but the problem persisted even after we replaced it.
Is it FMR51 or FMP51? Guided wave radar is also contactless
Nazi mad dog, going crazy there................ After evaluating B: lol