How to test a position transmitter
Thread Content
How to test this type of transmitter? It should be by pressing the gray button below the indicator light; when pressed, the flashing frequency of the light changes as well. Is it operating based on the frequency at which the light flashes?
It is recommended to look up or download the manual for the corresponding model online. A thorough understanding of the system helps with improvement.
For local calibration, should buttons and indicator lights be used, or should the 375/475 calibration method be employed? The attachment contains the manual downloaded from its official website
Hold it for three seconds, then the light will flash three times long and once short; after that, press it to turn it off completely, press it again to turn it on fully. It would be fine if the light stayed on all the time