475: Unable to bring DVC6200 into online mode during debugging

2020-03-11View Original

Thread Content

This post was last edited by yhb30203 on 2020-3-11 at 15:52. Guys, I’m using a 475 controller to configure the FISHER DVC6200. I followed the instructions in the attached PPT for setup, but after connecting the wires, supplying air at 0.4 MPa, and activating the signal power supply at 4 mA, I was able to enter Hart mode. However, when I tried to go to the “online” mode, I encountered the issue shown in the image. I tried this many times; I tested various values for the signal power supply ranging from 4 to 20 mA, but it kept getting stuck on that interface and I wasn’t able to enter online mode. Have any of you encountered this before? How do you solve it?

Reply #22020-03-12

Try using a 250-ohm resistor

Reply #32020-03-12

475, try restarting it once; it seems to be a problem with the DD file.

Reply #42020-04-19

Bro, your 475 version is too low

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

475: Unable to bring DVC6200 into online mode during debugging

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links