Yokogawa CS3000 installation issues
Thread Content
During the installation of the Yokogawa CENTUM CS3000, an entry for the path was required when installing the electronic manual, as the software is located on the hard drive. I would like to ask if the installation can be done by entering data into the hard drive? If possible, how should the path be entered and which file is the executable?
This post was last edited by jlshnlhj on 2020-8-26 22:00. CS3000 consists of 2 discs, and 2 disc image files can be obtained. The software CD is the CENTUM_SOFTWARE Rx.xx.00.iso disk image file, while the electronic manual CD is the CS3000_IM Rx.xx.00.iso disk image file. Load the software disc image, CENTUM_SOFTWARE Rx.xx.00.iso, using the virtual drive software VirtualDrivemaster or UltraISO; first run x:\CENTUM\COMDRV\setup.exe (YOKOGAWA Vnet/VLnet Protocol driver). Run x:\CENTUM\setup.exe again; when the installation process is about 92% complete, the installation software will prompt you to insert the electronic manual CD. At this point, uninstall the software CD from the virtual drive and then insert the electronic manual CD: CS3000_IM Rx.xx.00.iso. The installation will continue until it is complete. ,
That’s right; my file has been decompressed, and it’s no longer an ISO file but rather two folders. The first disc contains executable EXE files, which can be installed normally. When it is prompted to install the second disc, I want to enter the hard drive path, but I don’t know how to run the files on the second disc, as there are no executable EXE files visible, so I’m not sure how to proceed with the installation
This post was last edited by jlshnlhj on 2020-8-30 09:07; you can convert it back to an ISO file using UltraISO. A tip: When you need to create an image of a CD, it’s as if you already have that CD; this is particularly useful for CDs with boot loaders. It allows you to install operating systems in virtual machines, burn discs, and handle various tasks related to them.
This post was last edited by jlshnlhj on 2020-8-27 09:01. To convert it back into an ISO file using UltraISO: go to Operation\Add Directory\Point to... directory, and then select File\Save As.... On the electronic manual CD, there is also x:\Centum\READER\ENGLISH\FINDER.exe that needs to be installed; it is used for searching through the electronic manual when help is needed with configuration.