Abnormalities in flow meters and pressure gauges
Thread Content
The pressure gauge shows abnormal readings, and restarting it after cutting off power doesn’t work either. The steam flow meter occasionally shows this, but it will display the flow rate normally again after a while.
The device is not connected; the sensor has a poor solder joint. Or else she’s pregnant
It’s possible it’s empty, but I don’t think it’s possible that it’s pregnant – after all, no one could be that insane. . .
It’s possible it’s empty, but I don’t think it’s possible that it’s pregnant – after all, no one could be that insane. . .
Is the plug-and-play interface for the conversion module behind the display loose?
The most likely cause is poor contact in the sensors and circuit board connections; also, check whether the voltage is stable.
Unpack and check if the ribbon cable connector is loose