How to use the Fox pineapple valve positioner
Thread Content
I just bought two Foxboro valve positioners, but I don’t know how to configure them. Could some expert give me some advice? Thank you. ,
Just follow the instructions included with it; the trackers from this brand are relatively niche
https://mp.wei*n.qq.com/s?src=3×tamp=1624256246&ver=1&signature=dkvV8jzxc1h27EvM0armrjGoi4yYCClcxdWYnvim8ssdrIPLRFXdfFMTV3lFBkatpLRbKS6VqOwIMlDV2qvkNBnLLoOquJHqubZ0d4T71ZrHypWDjbX1haRg9MkEPUk7cK4o7EzzGQqEg4Bbw2Iv5DkCjkbK02-Ep96NGP08XOA=
There is no Chinese instruction manual; only an English version is available.
There is no Chinese instruction manual; only an English version is available.
Then try translating it: lol
There is no Chinese instruction manual; only an English version is available.
If there’s a part you don’t understand, copy and paste it into another translation tool to get it translated; it’s impossible not to know any English at all
One can only guess by looking at the images bit by bit or by scanning them with a phone; there’s always a way
First switch to the “out ser mode off” setting, then find “auto cal automatic calibration”; everything should be fine after that