Specifications for conical drilling sleeves for thermal resistor flange installation
Thread Content
This post was last edited by liu530014416 on 2022-2-22 23:03. Dear teachers, what are the specifications for the conical drilling sleeves used in the installation of thermal resistance flanges? I remember it being thick on top and thin at the bottom.
https://bbs.hcbbs.com/thread-3249812-1-1.html Please refer to the post above; on page 3 there is a selection table for our company’s overall drilling sleeves, with the corresponding specifications also listed there. Or are you asking about the standards followed in the design of rod sleeves? You can look up ASME PTC 19.3 online by yourself; if you need it, I can also send it to you