The Yokogawa VP6 cannot be used for simulation after installation
Thread Content
VP R6 is installed and authorized properly, but when simulating existing learning projects, the following message keeps appearing; I’m not sure what the cause is. bketestfunclnit.exe error: there are no licenses to start this module. Is there no authorization for this? How should I proceed? Thank you!
Yokogawa system simulation requires a simulation license, and this license must match the CPU model of the project for which it is being used; otherwise, an error will be generated； For example, if the authorization ID corresponds to Project A and you want to open Project B, then if Project B’s CPU is the same as or compatible with that of Project A, simulation is possible; otherwise, an error message will be displayed indicating that no authorization is available
Thank you for your reply! It’s been resolved; it was an issue with the simulation license not being assigned.