Thread Content
Since its introduction, radar level gauges have gained increasing favor among customers and have become important measuring instruments; more and more factories are starting to use the radar level gauges produced by our company for measurements. However, when using instruments, it is necessary to master certain usage techniques in order to reduce errors and avoid harm caused by human mistakes, thereby ensuring the accuracy of the radar level gauge and extending its service life. We have compiled three tips for everyone. https://p3-sign.toutiaoimg.com/tos-cn-i-qvj2lq49k0/20910bcc59fe4514adbefbfcc5ed8793~noop.image?_iz=58558&from=article.pc_detail&x-expires=1682648263&x-signature=ftEMN03UeUw2SgyGB6bIcBqTpY0%3D Images of on-site application: First of all, when using the instrument, it is necessary to pay attention to the specified measurement range; operating outside this range not only results in inaccurate data but can also damage the instrument. Secondly, when using a radar level gauge to measure materials with a low dielectric constant and there is very little material present so that the bottom of the tank is visible, to ensure the accuracy of the measurement values, the zero point can be adjusted upward to a position higher than the bottom of the tank. Finally, if the object being measured is in constant motion during measurement, accurate data cannot be obtained. In this case, the waveguide should be fixed to the bottom of the tank and welded at the midpoint, ensuring that the weld is smooth to prevent any bumps or irregularities from causing obstacles. These are the three tips for using radar level gauges; I hope they will be helpful to everyone. If you have any questions, feel free to ask online.