Problems with the tuning fork switch installation
Thread Content
Dear experts, when installing fork-type level switches on the side walls of storage tanks, it is necessary to prepare flange openings for specialized equipment; even when using horizontal short-pipe flanges, there is still a slope of 15~30°. Is it best to install the tuning fork switch horizontally, without any angle, to prevent material from getting stuck?
When installing the tuning fork level switch on the side wall of a storage tank, horizontal short pipe flange connections can be considered. If the angle of the reserved flange opening is between 15~30°, installation can also be considered. It should be noted, however, that whether it is installed horizontally or at an angle, it is necessary to ensure that the exposed length of the fork switch meets the required specifications, and that its contact point with the material inside the storage tank is properly positioned, in order to avoid false alarms or missed detections. Since the operating principle of a tuning fork switch is based on vibration frequency and amplitude, if it is not installed properly, it may cause false alarms or missed alarms, leading to abnormal operation of the equipment and even dangerous accidents. .
When installing, ensure that the tuning fork is perpendicular to the bottom of the tank.
Can it be installed on the top of the tank? Would it be more reasonable to install it on the top of the tank? Haven’t done it: Q