How to test the Brooks 5850E mass flow meter

The Brooks 5850E mass flow meter is an electromagnetic mass flow meter used to measure the mass flow rate of gases or liquids. During testing, first ensure that the power supply is connected correctly, and verify that the voltage meets the device’s requirements. Then, proceed with the testing following these steps: 1. Check the connections of the instruments: Ensure that the connection between the sensor and the display is proper, and verify that the connection plugs are secure. 2. Check the valve status: Ensure that the medium to be measured by the flow meter can pass through the instrument, and confirm that the valve is in the open position. 3. Check the instrument settings: Adjust the parameters of the instrument according to the properties of the medium being measured and the requirements of the experiment, such as unit selection and temperature correction. 4. Check the instrument’s operating status: Verify whether the display screen shows the flow rate values correctly. If no values are displayed or the display is abnormal, it may be due to a malfunction in the instrument. 5. Perform zero calibration: With no flow passing through, carry out the zero calibration to set the instrument reading to zero. For specific calibration methods, please refer to the instrument’s user manual. If the testing was carried out according to the steps above and the instrument still does not respond, the following problems may exist: 1. Power supply issue: Verify that the power connection is correct and that sufficient voltage is supplied. 2. Instrument failure: If it still cannot function properly, there may be a fault with the instrument itself; it is recommended to contact Brooks Company’s customer service department for repair or replacement. Finally, it is recommended that you read the instrument’s user manual to learn about the specific testing procedures and troubleshooting methods. .

This post was last edited by tiger2010 on 2023-7-9 07:58. Is this used in an analyzer? Specifically, which model of 5850 is it? On the official website, its configurations are listed in many variations