Design of denitration flue supports
Thread Content
In the design of denitration flue supports, how is it determined where fixed supports should be installed, where limit supports should be placed, and where guide supports should be used? ? Is there a precise calculation method and basis? Thank you! ! ! Standards, manuals, books
It depends on the layout; there are no strict standards in China yet, so a design plan can’t be based on just one factor
Most of what you mentioned is derived through stress calculations along with appropriate tolerances
Specifically, it requires calculation; first, stress is considered to determine the strike and support location. Large pipes need to be supported with calculated loads. Determine the bracket type.