Purification packed tower
Thread Content
The hole diameter is 2mm, the outlet of the packed tower pump is DN400, and the pressure is 0.4 MPa. Can this satisfy the liquid volume on the packed tower? Ask for expert advice! !
Ask the manufacturer about the effective filtration area S of the filter~~The pipeline cross-sectional area is calculated as S1, then S/S1 is greater than or equal to 3~~Simple selection method~~
Purify the dilute acid filter, clear it regularly, and remove debris to prevent clogging.
Remove the impurities in the dilute acid that will clog the replacement plate.
In the early stages of driving, there are many large debris and a filter is needed. Later, you can remove the filter, and the filter and plate will always have to be blocked.
In the early stages of driving, there are many large debris and a filter is needed. Later, you can remove the filter, and the filter and plate will always have to be blocked.
In the early stages of driving, there are many large debris and a filter is needed. Later, you can remove the filter, and the filter and plate will always have to be blocked.
In the early stages of driving, there are many large debris and a filter is needed. Later, you can remove the filter, and the filter and plate will always have to be blocked.
In this case, firstly, the amount of waste acid discharged from the purification process must be increased, and the amount of acid flowing through the cooling tower must be increased! The second is to control the electrostatic dust collection indicators. It should be possible to change