Instructions for Configuration and Commissioning of E+H Electromagnetic Flowmeters and Mass Flowmeters
Thread Content
Recently, a new installation was put into operation at my workplace, and many E+H flowmeters were installed, including both electromagnetic and mass-type ones. However, I’m not very familiar with their setup and configuration. If any expert could provide detailed instructions, I would be extremely grateful. For example, many flow meters keep showing negative values, both for instantaneous and cumulative readings. The sensor’s detection direction was changed before, but with little effect; it was adjusted again through the settings. I’m seeking advice from experienced professionals. I also hope the technicians can provide some troubleshooting instructions for E+H. Thank you!
Go to endress.com.cn, which is the official website of E+H, and then search for your instrument model – all the relevant information will be available there
There is a manufacturer from E+h in the group; you can contact them to get some materials
Is it in our group? I’ll go take a look, thank you!
Is this flow meter effective? How does it compare to the electromagnetic ones from Corlon?
It’s okay, the level gauges used in our facility are from E+H
E+H is okay too; it’s used by many companies, especially most of those that have been established recently