Heat transfer printer heat transfer process

Thread Content

I. Special heat transfer printer inks, specialized heat transfer paper, and specially treated gift-related supplies. II. Basic operating procedure of the heat transfer printing machine: Note that the entire machine must have a properly connected protective ground wire. 1. Plug in the power supply and turn on the power switch; the power indicator light will then turn on. 2. Adjust the thermostat to the desired temperature, and set the timer for the required time. 3. Hold the handle and push the heating plate away ； 4. Place the clothing flat on the lower ironing plate, cover it with ironing paper (make sure to turn over both sides of the paper), move the heating plate back to its original position, and press the handle down firmly until it reaches the end. 5. When the set time for indicial hot stamping expires, an alarm is issued (the buzzer sounds); lift the handle back to its original position to push the hot stamping plate away. 6. Tear off the heat transfer paper to complete the process. 7. Successful heat transfer requires the precise combination of time, temperature, and pressure; the thickness and material of the garment, as well as the type of heat transfer paper, all affect the outcome of the heat transfer process. III. Adjusting the pressure: 1. Pressure: If the pressure is too low or too high, first loosen the pressure-regulating locking screw, then turn the pressure-regulating nut to adjust the pressure; once adjustment is complete, tighten the pressure-regulating locking screw again. 2. Time: When the stamping time is reached and the buzzer does not sound or keeps sounding, it is necessary to check whether the contact point of the microswitch in the machine’s rear compartment is at an appropriate distance; if not, it must be adjusted to the correct position. 3. Temperature: When the desired temperature is reached, the pointer of the thermostat’s controller will be at the “0” position (it takes about 15 minutes to reach 180 degrees). If the heating element does not heat up even after the device has been running for a few minutes, please check the circuit. IV. Product features: 1. This machine can be used to print patterns on clothes, pillows, phone cases, mouse pads, puzzles, metal sheets, makeup mirrors, keychains, porcelain pieces, stone art, and more. 2. The operation is simple and fast; the cost is low, making it suitable for those with limited budgets. 3. The products produced are both attractive and practical, and they are popular among people of all ages, offering great market prospects. Article source: China Printing Trade Network yinhua,99114,com