Regarding the setup of loading for ANSYS nonlinear calculations
Thread Content
A device is subjected to two types of loads: external pressure and gravity. During nonlinear calculations, can the external pressure be applied linearly (KBC,0), while keeping gravity constant?
One still has to figure it out on their own; multiple load steps can be used for this
In ANSYS, loads can be superimposed, and multiple load steps can be implemented. The trend now is WB; why are you still using classic?
There are many projects involving similar equipment; I’ve written quite a few APDL command sequences before, and they work quite well – report generation is also fast. I’m also learning WB, but I haven’t applied it in actual work yet