PDS Seeking Help Season 2
Thread Content
PDS pick list line chart issue. The same pipeline number has several diameter changes; for example, 200-150-100. The medium is MS. When generating a single-line diagram, all three pipes should be shown, namely 200-MS, 150-MS, and 100-MS. Sometimes generating diagrams for all of them results in errors, and other times it works, but only one diagram is produced. This applies even to the entire pipeline from 100 to 200 – the corner marker shows only 100-MS. What’s going on?
I’ve never used the PDS software; waiting for experts to reply!
I’m not sure whether you draw individually or in batches; it’s recommended to use BATCH drawing instead. If nothing comes out or an error occurs, it might be a problem with the tubes – check the error report for any relevant information.