What should be noted during the individual test run of a heat transfer oil heating system?
Thread Content
Since a new heat transfer oil heating system has been purchased, what should be noted during the individual unit testing, and what are the key operating points? (The heat transfer oil system mainly consists of a heat transfer oil tank, an expansion tank, an oil-gas separator, an electric heater, and its pumps)
Be careful not to increase the temperature too quickly, to avoid boiling oil. Start by performing a cold cycle to release the air from the system, and then gradually increase the temperature to heat the oil. You can contact me for details.
What kind of oil is heat transfer oil?
Raise the temperature in accordance with the heating curve; do not allow water to enter the heat transfer oil system. Heat transfer oils are divided into mineral oils and synthetic oils. Mineral oils have a composition similar to that of lubricants, while synthetic oils are generally composed of a single chemical component, such as monobenzyltoluene, dibenzyltoluene, xylene ether, etc