Urgent help needed: mechanical impurities
Thread Content
Dear sea gods, does anyone know how to remove mechanical impurities from the slurry? I reduced the ash content by changing it from 0.35 to 0.002, but the mechanical impurities hardly changed, going from 0.6 to 0.4. This isn’t very satisfactory. Does anyone among you have any other ways to deal with this issue? Thank you
This post was last edited by wlf1234 on 2015-12-20 08:38. Gray scale is used for most sampling tasks, but mechanical impurities have not been tested yet. Does it have any impact? Equipment wear?
What advanced technology can reduce the ash content from 0.35 to 0.002?
How can the ash content be reduced as much as possible? Solve it, please.