How to set the output density signal for Emerson mass flow meters
Thread Content
Can Emerson mass flow meters be set to output a density signal? How does one set up the output of a density signal?
The output density signal can be configured in the menu; current output is generally used
It should work! Most of them are high-quality output models! But the density can be displayed in the table header!
Could you be more specific? Is it a modification using a Hart communicator? How to operate
It’s possible to do it using a handheld controller; if no handheld controller is available, configuration can also be done through the menu – take a look at the menu for details.
There is no other answer to this question – definitely yes； As for how to set it up, I know there are two ways: one is using their dedicated software, ProLink, and the other is using a manual controller. Both of these have configuration functions; you just need to select the appropriate options under configuration ； As for whether it can be set on the interface (LCD), I haven’t set it myself, so it’s difficult for me to comment on.