How to handle infinite loops when analyzing pump inlet and outlet pipelines
Thread Content
The friction coefficient of the support near the pump nozzle is taken as 0.3
First, check whether there is any support that has become unsupported; when in an infinite loop, pressing F2 will prompt the location of the unsupported point. Find that point, remove the friction coefficient, and try again.
The bracket has come loose; adjust its position
May I ask if the friction coefficient of the first support at the outlet of the pump nozzle can be removed?
The friction at the first support at the pump outlet can have a significant impact on the pump nozzle; if there is any clearance in this area, it is recommended to use a spring-mounted support. If no clearance is present, friction can be reduced by adding sliders or by adjusting the path. Your question is too general; it’s not possible to simply answer whether it’s possible or not.
I just started learning *stress analysis; I don’t have enough knowledge yet