6 kilograms of saturated steam converted to 16 kilograms of superheated steam
Thread Content
Our unit wants to convert 6 kilograms of saturated steam into 16 kilograms of superheated steam. What are some good methods for this, and what equipment is needed? Please share your suggestions.
http://bbs.hcbbs.com/thread-1032412-1-1.html It was discussed on the forum before. There has never been a precedent for such conditions; in my opinion, the only solution is to add boilers, pumps, and other equipment. The source of steam can be considered as condensed water recovery, because at 16 kilograms, the steam source is condensed water.
Upgrade to high-pressure boiler； Pressure can only be reduced, not increased; the temperature of superheated steam can be increased. I’ve never seen such a conversion device.
Turbocharging, but in this case it’s better to just replace the boiler
Can steam be allowed to pass straight out from the flue gas side of the waste heat boiler? Add a control system to regulate the pressure? I don’t understand; I’m just an amateur asking questions randomly
Temperature can be increased by injecting high-pressure superheated steam
Use a compressor? I don’t understand it; I think that’s the principle behind MVR, but the temperature rise shouldn’t be too high
This isn’t cost-effective; it’s better to use a boiler to produce 16 kilograms of superheated steam directly.
Use a piston reciprocating pump to increase the pressure to 20 kilograms, then heat it with the residual heat, and that’s it