Who is more familiar with AFT Fathom or Arrow software? Emergency! ! !
Thread Content
This post was last edited by smilingyan on 2016-7-18 12:53. In AFT’s fluid calculation software, if the resistance loss model for the tee is set to “detail”, where can I find the pressure drop value for this tee in the output results? There are multiple losses in the output, with 2 k values; however, it seems that the Fanning formula is not being used for verification, so it’s unclear how to calculate the voltage drop using these k values. No relevant instructions can be found in the help section either. . . Thank you, I’m in a hurry; does anyone have any advice?
This post was last edited by Engineering-Rebel on August 15, 2016, at 17:44. For such local components, calculation methods used by certain American manufacturers are employed; it definitely isn’t the Fanning formula. If you have any further questions, feel free to contact me via private message