【Daily Question】Chemical Engineering Principles 368: Locations of oxygen corrosion in boilers (May 4)
Thread Content
This post was last edited by “Back to Cambridge” on May 18, 2016, at 08:32. Starting today, the Chemical Engineering Theory section will launch the “Question of the Day” activity to help everyone reinforce their basic knowledge in chemical engineering. Subsequently, series such as “Fundamentals of Chemical Engineering”, “Mass Transfer and Separation”, “Chemical Thermodynamics”, and “Chemical Process Technology” will also be introduced. We hope for your active participation! Wishing you all a Merry Christmas~~ For replies to the “Question of the Day” activity, answers can be viewed directly; however, the thread will be closed after one day! ! To encourage continued participation from everyone this year! Participation earns 3 wealth points, with an additional 4 wealth points for correct answers~~~ Short answer question: Where is the part of a boiler in operation that is most prone to oxygen corrosion? It is usually at the water supply pipeline and the inlet of the economizer.
At the water supply pipeline and the economizer inlet.
It is usually at the water supply pipeline and the inlet of the economizer.
.A. Superheater B. Header C. Economizer D. Heated surface
Where is the area most prone to oxygen corrosion in a boiler that is in operation? Answer: The part of a boiler in operation most prone to oxygen corrosion is the inlet end of the coal burner.
Where is the area most prone to oxygen corrosion in a boiler that is in operation? Answer: The parts of a boiler in operation most prone to oxygen corrosion are the feedwater pipes and the inlet end of the coal burner.